>  
Key Aspects of Product Marking with Conformity Mark in Morocco
  >  
Key Aspects of Product Marking with Conformity Mark in Morocco

Key Aspects of Product Marking with Conformity Mark in Morocco

The Ministry of Industry, Investment, Trade and Digital Economy of Morocco published the Law 24-09 on the Safety of Products and Services to protect the users of industrial products distributed on the Moroccan market.

The law aims to:

- prevent accidents related to the use of products

- guarantee consumer confidence

- strengthen the responsibility of economic operators

- strengthen market surveillance

- ensure product compliance with current regulations

- bring Moroccan legislation closer to international practices

- facilitate compensation for victims of dangerous products

This law, which establishes the obligation for any importer or manufacturer to mark its products, is valid for three categories of products:

 

  • electrical equipment intended to be used within certain voltage limits  
  • equipment affected by electromagnetic compatibility  
  • toys

The above-mentioned categories of products should meet the requirements of the relevant national technical regulations of Morocco before being able to affix the Cم. mark.

However, once the product meets the technical regulations requirements, the manufacturer should draw up a declaration of conformity by which he confirms that the product meets the essential safety requirements provided for by the specific technical regulations applicable to that product.

This declaration of conformity must contain:

- products identification information

- name and address of the manufacturer

- reference to the standards applied

The declaration of conformity must be kept and made available to the competent authority upon the request for a period of at least ten years.

Thus, the conformity mark shows that the product meets the requirements of the relevant national technical regulations and is safe. Taking into account the fact that  foreign manufacturers can not immediately affix the conformity mark, especially in the case when families of products intended to be put to the world market, it was decided not to control the presence of the mark strictly up to November 2021, provided that the manufacturers undertake to initiate the procedure for affixing the mark.

Please note that it is strictly forbidden to affix the mark if the product doesn’t meet the relevant requirements. Moreover, if during the market surveillance the authority finds product that does not comply with the regulations, the following sanctions can be applicable:  

  • imprisonment for the period from 3 months to 2 years  

and/or

  • a fine from 50,000 to 1,000,000 Dh (5 000 — 100 000 USD approximately)

Graphic representation of the conformity mark of Morocco

When applying the conformity mark on your products, be sure that the vertical dimension of the letter "C" is not less than 6 mm.

The mark shall be affixed visibly, legibly, and indelibly to the electrical and electronics products or to its data plate.

Latest News

Safety
 hours ago
Colombia Issues Resolution on COVID-19 Prevention Measures
Medical
 hours ago
European Union Establishes Clinical Investigation Application/Notification Document MDCG 2021-08
Energy efficiency label requirements in Ukraine
 hours ago
Energy Efficiency label requirements for televisions in Ukraine
 hours ago
Energy Efficiency Labeling for Vacuum Cleaners in Ukraine
 hours ago
Use of Energy Efficiency Label for Household Tumble Dryers in Ukraine
 hours ago
Colombia Issues Resolution on COVID-19 Prevention Measures
 hours ago
European Union Establishes Clinical Investigation Application/Notification Document MDCG 2021-08
 hours ago
Energy efficiency label requirements in Ukraine
 hours ago
Energy Efficiency label requirements for televisions in Ukraine
 hours ago
Energy Efficiency Labeling for Vacuum Cleaners in Ukraine
 hours ago
Use of Energy Efficiency Label for Household Tumble Dryers in Ukraine

Contact Us

Thank you! Your submission has been received!
Oops! Something went wrong while submitting the form.